Charging
ODYSSEY® batteries
The information on this page discusses battery charging. For
available battery chargers, click
here
Proper Charger Selection
A critical factor in the proper use of a rechargeable battery
is charging. Inadequate or improper charging is the most common
cause of premature failure of rechargeable lead acid batteries.
Small, portable automotive chargers may be used to charge your
ODYSSEY® battery. These chargers are essentially
designed to bring a discharged battery to a state of charge
(SOC) that is high enough to crank an engine. Once this is
successfully accomplished it is up to the engine alternator to
fully charge the battery. It is important to keep this design
philosophy in mind when using this type of charger.
There is another class of chargers that is designed specifically
to maintain the battery in a high state of charge. These
chargers, such as the 1.25 amp Battery Tender® from
Deltran are not capable of charging a deeply discharged ODYSSEY®
battery. This is due to the fact that
these chargers have very low output power. They should only be
used either to continuously compensate for parasitic losses or
to maintain a trickle charge on a fully charged stored battery.
(A)
Selecting the right charger for your
battery
Small portable automotive chargers can also be used, as long
as certain suitability criteria are met. Qualifying these
chargers for your ODYSSEY® battery is a simple two-step process.
Step 1 - Charger output voltage
Determining the charger output voltage is the most important
step in the charger qualification process. If the voltage
output from the charger is less than 14.2V or more
than 15V for a 12V battery do not use the charger.
This output voltage is measured on the battery terminals
with the charger charging, the voltage is steady and the output
current has begun to decline. For 24V battery systems the
charger output voltage should be between 28.4V and 30V. If the
charger output voltage falls within these voltage limits when
the battery approaches a fully charged state, low output
current, proceed to Step 2; otherwise pick another charger.
Step 2 - Charger type — automatic or manual
The two broad types of small, portable chargers available today
are classified as either automatic or manual.
Automatic chargers can be further classified as those that
charge the battery up to a certain voltage and then shut off and
those that charge the battery up to a certain voltage and then
switch to a lower float (trickle) voltage.
An example of the first type of automatic charger is one that
charges a battery up to 14.5V, then immediately shuts off. An
example of the second type of automatic charger would bring the
battery up to 14.5V then switch to a float (trickle) voltage of
13.6V; it will stay at that level indefinitely. The second type
of automatic charger is preferred as the first type of charger
is likely to undercharge the battery.
A
manual charger typically puts out a single voltage and has to be
manually switched off to prevent battery overcharge. Should
you choose to use a manual charger with your ODYSSEY®
battery, do not exceed charge times suggested in Table III
below.
(B)
Selecting battery type on your charger output
While it is not possible to cover every type of battery charger
available today in a product guide such as this, this section
will try to give the ODYSSEY® battery user some
general charger usage guidelines to follow, after the
charger has been qualified for use with this battery.
In general, do not use either the gel cell or maintenance free
setting, if provided on your charger. Choose the deep cycle
option, should there be one on your charger. Table III below
provides suggestions on charge times based on charger currents.
Table III: Suggested charge times for ODYSSEY®
batteries
|
Model |
Charge time for 100% discharged battery |
|
10A charger |
20A charger |
|
PC 310 |
48 minutes
|
24 minutes
|
|
PC 535 |
1.5 hour
|
45 minutes
|
|
PC 545 |
1.5 hour
|
45 minutes
|
|
PC 625 |
2 hour
|
1 hour
|
|
PC 680 |
2 hour
|
1 hour
|
|
PC 925 |
2.5 hour
|
1.25 hour
|
|
PC 1200 |
4 hour
|
2 hour
|
|
PC 1700 |
7 hour
|
3.5 hour
|
|
PC 2150 |
9 hour
|
4.5 hour
|
Note that the charge times recommended in Table III are based on
an assumption that the ODYSSEY® battery is fully
discharged with an open circuit voltage of 11.6 volts. If the
battery is only partially discharged the charge times should be
appropriately reduced.
Sealed Rechargeable DrycellTM - Deep Cycle Batteries
|